Technical Support

Mobile Broadband - TP-Link TL-MR3220 - Setup


Note: For initial configuration of your 3G Wireless Router, we advise to connect your PC directly to the router.

Step 1:

Connect the 3G Modem to the USB port at the back of the TP-Link TL-MR3220 Router.

Connect the 3G modem

Plug the network cable to your PC and the other end of the cable into your modem.

Turn the TP link on and wait about 1-2 minutes for it to boot up.

Step 2:

Open an internet browser page and enter: 192.168.1.1 into the address bar.

TPlink3G-1

Step 3:

You will then be prompted for a Username and Password. Enter the following:

  1. Username: admin
  2. Password: admin

TPlink3G-2

Step 4:

Select Quick Start on the left hand side, followed by the Next button.

TPlink3G-3

Step 5:

Select 3G Only, followed by the Next button.

TPlink3G-4

Step 6:

Choose to set the Dial number and APN manually and enter the settings as shown in the figure below.

  1. Dial Number: *99#
  2. APN: splns999a1

TPlink3G-5

Step 7:

Choose the appropriate wireless settings for your network. WPA-PSK/WPA2-PSK is recommended.

TPlink3G-6

Step 8:

The router is now configured, you will need to reboot the device to complete the process. To do this press the reboot button on the screen.

TPlink3G-7

Allow 1-2 minutes for the reboot to take place and you should be able to access the internet.