Technical Support

Mobile Broadband - Netgear MBR624GU 3G Router Setup

Plug the 3G modem into the USB slot on the back of the Netgear Router (or into USB extendor supplied then into the router). Then plug in the Ethernet cable from the LAN Port on the back of the router into your PC or Laptop (windows should automatically set it up).

Turn on the device and open Internet Explorer

generic

In the address bar enter: 192.168.0.1 as shown. Press Enter or Go.

netgearaddress

It will ask you for a username and password. Enter 'admin' as the username and 'password' as the password and press Enter or click OK

netgearlogin

The following screen will appear. If it doesn't, click on Setup Wizard in the left hand menu. Click Next

netgear1

The router will now detect your connection

netgear2

Once it's done, you will see the following screen; Enter the settings as shown and click Next

netgear3

In the following screen, enter the settings as shown and click Next
(Please note: APN = splns999a1 (lower case L after p)

netgear4

The modem will update its settings

netgear5

It will then attempt to connect to your internet connection based on the settings entered

netgear6

Once it's done connecting, the Netgear will prompt you to setup your wireless security. It's generally good practice to enable this. Select Australia and click Next

netgear7

It will prompt you to enter a name for your wireless network. You can leave it as the default or change it to one you prefer. Once you have decided on a network name, click Next

netgear8

Click on Yes to setup a security password on your network

netgear9

The security type that is selected is WPA-PSK + WPA2-PSK. Click Next

netgear10

Type in password between 8 and 63 characters to use and a network security key and click Next

netgear11

You will now be shown a summary of settings. Click Finish at the bottem

netgear12

If it asks you about updating the firmware, untick the box that says Check for Updated firmware Upon login

netgear13

When prompted about cancelling the update, just click OK

netgear14

On the Broadband settings page, click Connect if it doesnt already say connected at the bottom

netgear15

You should now be able to browse the internet