Plug the 3G modem into the USB slot on the back of the Billion Router. Then plug in the Ethernet cable from the LAN Port on the back of the router into your PC or Laptop (windows should automatically set it up).
Turn on the device and open Internet Explorer
Type the following in the address bar: 192.168.1.254
When prompted for a username and password, type:
Once logged in click on Advanced on the left hand side.
Click on Configuration, click on WAN, and then click on WAN Interface.
Change the Main Port to 3G and click on Apply.
Click on WAN Profile on the left hand side:
Set it up as follows. Then click on Apply.
Please note, the l is a lower case L.
Click on ADSL Mode on the left hand side.
Set the settings as follows. Click on Apply.
Click on Save Config at the bottom.
Click on Apply to save the settings to flash.
Click OK when the successful message comes up.
You have now setup your Billion Router successfully.
All times are Australian Eastern Daylight Time (AEDT)
Customers experiencing service difficulties should check our Network Status page for known issues before troubleshooting.