CHAT NOW

Support Home  >  Mobile Broadband  >  TP-Link TL-MR3220 Setup

Mobile Broadband

TP-Link TL-MR3220 Setup


Note: For initial configuration of your 3G Wireless Router, we advise to connect your PC directly to the router.

Step 1:

Connect the 3G Modem to the USB port at the back of the TP-Link TL-MR3220 Router.

Connect the 3G modem

Plug the network cable to your PC and the other end of the cable into your modem.

Turn the TP link on and wait about 1-2 minutes for it to boot up.

Step 2:

Open an internet browser page and enter: 192.168.1.1 into the address bar.

Step 3:

You will then be prompted for a Username and Password. Enter the following:

  1. Username: admin
  2. Password: admin 

Step 4:

Select Quick Start on the left hand side, followed by the Next button.

Step 5:

Select 3G Only, followed by the Next button.

Step 6:

Choose to set the Dial number and APN manually and enter the settings as shown in the figure below.

  1. Dial Number: *99#
  2. APN: splns999a1 

Step 7:

Choose the appropriate wireless settings for your network. WPA-PSK/WPA2-PSK is recommended.

Step 8:

The router is now configured, you will need to reboot the device to complete the process. To do this press the reboot button on the screen.

Allow 1-2 minutes for the reboot to take place and you should be able to access the internet.

GUIDES

This knowledgebase contains helpful guides which cover a wide range of topics.

CUSTOMER SERVICE

Call us on 1300 303 375 or log in to My Account and request a callback at a time that suits you.

  • 8:00am to 8:00pm weekdays
  • 9:00am to 5:00pm weekends and holidays

All times are Australian Eastern Daylight Time (AEDT)

NETWORK STATUS

Customers experiencing service difficulties should check our Network Status page for known issues before troubleshooting.

BACK TO KNOWLEDGEBASE

CAN WE HELP YOU CHOOSE THE RIGHT PLAN?

Our gurus will help you get started, and happily help you out.

CALL US ON 13 22 10
OR WE CALL YOU

Take a look at our FAQ